MAD HATTER PEPTIDES 🎩
Educational Reference & Coaching Portal
⚠️ FOR RESEARCH USE ONLY. NOT FOR HUMAN CONSUMPTION.
Standard Reconstitution Protocol
Visual step-by-step laboratory technique for research preparation.
- Sanitize Vials: Thoroughly wipe the rubber stoppers of both the diluent (BAC water) and peptide vials with individual alcohol prep pads. Allow to air dry completely.
- Draw Diluent: Using a sterile mixing syringe, draw the exact measured volume of Bacteriostatic Water required for your target concentration.
- Inject Down Vial Wall: Insert the needle at an angle against the inside glass wall. Slowly drip the diluent down the glass. Do not spray directly onto the lyophilized powder.
- Swirl Gently: Gently swirl or roll the vial between your palms until the powder dissolves fully into a clear solution. Never shake the vial vigorously.
- Storage & Temperature: Store the reconstituted solution in a refrigerator at 2°C–8°C (36°F–46°F), upright and shielded from direct light and excessive heat.
Laboratory Reference Schedule
Reference subcutaneous titration protocols for experimental in-vitro modeling study.
| Timeline | Research Dosage |
|---|---|
| Weeks 1-2 | 1.25mg (0.06ml or 6 units) SQ once weekly. |
| Weeks 3-6 | 2.5mg (0.13ml or 13 units) SQ once weekly. |
| Weeks 5-8 | ~5mg (0.25ml or 25 units) SQ once weekly. |
| Weeks 9-12 | ~7.5mg (0.4ml or 40 units) SQ once weekly. |
| Weeks 13-16 | 10mg (0.5ml or 50 units) SQ once weekly. |
| Weeks 17-20 | 12.5mg (0.65ml or 65 units) SQ once weekly. |
| Week 21 onwards | 15mg (0.75ml or 75 units) SQ once weekly (maximum dose). |
*Note: SQ indicates subcutaneous injection.